Toyota Sienna Service Manual: Rear speed sensor (for 2wd)

Installation

HINT: Install the RH side by the same procedures with LH side. 1. INSTALL FRONT SPEED SENSOR LH (a) Install the speed sensor front LH with the bolt. Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) NO ...

Removal

HINT: Remove the RH by the same procedure as the LH side. 1. REMOVE REAR WHEEL 2. SEPARATE SKID CONTROL SENSOR WIRE (a) Disconnect the connector from the skid control sensor. 3. REMOVE REAR ...

Other materials:

Security Horn Circuit
DESCRIPTION During the alarm sounding state, the relay in the ECU turns on and off in a cycle of approximately 0.2 seconds, causing the security horn to sound. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT SECURITY HORN ASSEMBLY Disconnect the T1 security horn connector.  C ...

Reassembly
1. INSTALL FRONT SEAT CUSHION SHIELD LOWER LH  Install the front seat cushion shield lower LH. 2. INSTALL FRONT SEAT CUSHION SHIELD LOWER RH 3. INSTALL RECLINING ADJUSTER INSIDE COVER LH  Install the reclining adjuster inside cover LH (upper) with the screw. 4. INSTALL RE ...

Poor Sound Quality in All Modes (Low Volume)
INSPECTION PROCEDURE 1 CHECK AUDIO SETTINGS Set "BASS", "MID", and "TREB" to the initial values and check that sound is normal. OK: Malfunction disappears. 2 COMPARE WITH ANOTHER VEHICLE OF SAME MODEL Compare with another vehicle of the same model. ...