COMPONENTS
REMOVAL
1. REMOVE REAR WIPER BLADE ASSEMBLY
NOTICE: Be careful not to break the claw.
NOTICE: Do not fold the rear wiper arm with the rear wiper blade being removed from it.
2. REMOVE REAR WIPER RUBBER
NOTICE: Do not pull out the wiper rubber forcibly.
Otherwise, the backing plates are deformed or blade claw is damaged. HINT: Pushing the position close to the middle of the blade raises the rubber, making easier to pull the rubber out.
INSTALLATION
1. INSTALL REAR WIPER RUBBER
NOTICE: Be sure to install the wiper rubber backing plates in the right direction.
Hood
COMPONENTS
Adjustment
HINT:
Since a centering bolt is used as a hood hinge mounting bolt
and hood lock mounting bolt, the hood and hood lock can not
be adjusted with them on. Substitute a bolt with a washer for
the centering bolt.
1. INSPECT HOOD SUB-ASSEMBLY
Check that the clearance is ...
Eject Error/ Elevator Error/ Clamp Error
DTC 44-45 Eject Error
DTC 44-51 Elevator Error
DTC 44-52 Clamp Error
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
44-45
Disc cannot be ejected.
Television display assembly
44-51
Mechanical error occurs during elevator operation.
...
Room temperature sensor
On-vehicle inspection
1. INSPECT A/C ROOM TEMPERATURE SENSOR
(a) Remove the A/C room temperature sensor.
(b) Measure the resistance according to the value(s) in
the table below.
Standard resistance
NOTICE:
Even slightly touching the sensor may
change the resistance value. Be sure ...