Toyota RAV4 manuals

Toyota Sienna Service Manual: Reassembly

1. INSTALL SHOCK ABSORBER ASSEMBLY FRONT LH

2. INSTALL FRONT COIL SPRING INSULATOR LOWER LH

(a) Install the front coil spring insulator lower LH onto the shock absorber assembly front LH.

3. INSTALL FRONT SPRING BUMPER LH

(a) Install the front spring bumper LH to the piston rod.

4. INSTALL FRONT COIL SPRING LH

INSTALL FRONT COIL SPRING LH

(a) Using SST, compress the front coil spring LH.

SST 09727-30021 (09727-00010, 09727-00021, 09727-00031)

NOTICE: Do not use an impact wrench. It will damage the SST.

HINT: Use 2 SST of the same type.

(b) Install the front coil spring LH to the shock absorber assembly front LH.

HINT: Fit the front coil spring insulator lower LH into the gap of the shock absorber assembly front LH.

5. INSTALL FRONT COIL SPRING INSULATOR UPPER LH

INSTALL FRONT COIL SPRING INSULATOR UPPER LH

(a) Install the front coil spring insulator upper LH as shown in the illustration.

6. INSTALL FRONT COIL SPRING SEAT UPPER LH

INSTALL FRONT COIL SPRING SEAT UPPER LH

(a) Install the front coil spring seat upper LH to the shock absorber assembly front LH with the mark facing to the outside of the vehicle.

7. INSTALL FRONT SUSPENSION SUPPORT LH BEARING

INSTALL FRONT SUSPENSION SUPPORT LH BEARING

(a) Install the front suspension support LH bearing.

8. INSTALL FRONT SUSPENSION SUPPORT SUBASSEMBLY LH

INSTALL FRONT SUSPENSION SUPPORT SUBASSEMBLY LH

(a) Install the front suspension support sub-assembly LH with the mark facing to the outside of the vehicle.

(b) Temporarily tighten a new lock nut.

Inspection
1. INSPECT SHOCK ABSORBER ASSEMBLY FRONT LH (a) Compress and extend the shock absorber rod and check that there is no unusual resistance or unusual sound during operation. If there is any ab ...

Installation
1. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING (a) Install the front shock absorber with coil spring as shown in the illustration. (b) Install the 3 nuts to the upper side of the front shoc ...

Other materials:

Installation
1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) (See page EC-39) 2. INSTALL FRONT EXHAUST PIPE ASSEMBLY (a) Install a new gasket to the front exhaust pipe assembly. (b) Install the front exhaust pipe assembly with the 2 nuts. Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf) 3. V V(A) ins ...

DVD Player Mechanical Error/ DVD Insertion and Ejection Error/ DVD Reading Abnormal
DTC 44-10 DVD Player Mechanical Error DTC 44-11 DVD Insertion and Ejection Error DTC 44-12 DVD Reading Abnormal DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-10 A mechanical error in the DVD player is detected while the DVD is not being inser ...

Slide Door Closer RH does not Operate
DESCRIPTION The slide door ECU RH controls the slide door closer. In response to the signals output from the switches in the slide door lock, the slide door closer drives the closer motor. HINT: The slide door closer system operates regardless of the power slide door main switch ON / OFF. W ...

В© 2011-2024 Copyright www.tsienna.net