1. INSTALL BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY
(a) Apply lithium soap base glycol grease to the 2 brake master cylinder union grommets and install them to the brake master less reservoir tank cylinder subassembly.
(b) Using a pin punch (φ 5 mm) and hammer, install the master cylinder union with the pin.
(c) Install the 2 new O-rings.
(d) Install the brake master less reservoir tank cylinder sub-assembly with the 2 nuts and, 2 bolts.
Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
NOTICE: When the diameter converting unit and master cylinder are connected, install the No. 3 piston with no looseness.
(e) Using SST, install the brake tube to the brake master cylinder.
SST 09023-00101 Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
(f) Install the new O-ring.
System description
1. SYSTEM DESCRIPTION
(a) ABS
(Anti-lock Brake System)
The ABS helps prevent wheels from locking when
the brake is applied firmly or when braking on a
slippery surface.
(b) EBD
(Electronic Brake force Distribution)
The EBD control utilizes ABS, realizing proper
brake force distribution betw ...
Erasing the entire HomeLink® memory (all three programs)
Press and hold down the 2 outside
buttons for 10 seconds until
the indicator light flashes.
If you sell your vehicle, be sure to
erase the programs stored in the
HomeLink® memory.
Before programming
Install a new battery in the transmitter.
The battery side of the transmitter must ...
Rear wheel alignment
ADJUSTMENT
NOTICE:
For vehicles equipped with VSC, if wheel alignment has
been adjusted, and if suspension or underbody
components have been removed/installed or replaced, be
sure to perform the following initialization procedure in
order for the system to function normally:
1. Disconnect the ...