1. INSTALL REAR DISC
(a) Aligning the matchmarks, install the rear disc.
HINT: Select the installation position where the disc has the minimum runout.
2. INSPECT DISC RUNOUT
(a) Temporarily fasten the disc with the hub nuts.
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
(b) Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the disc.
Maximum disc runout: 0.10 mm (0.0039 in.) (c) If the disc runout is the maximum value or greater, check the bearing play in the axial direction and check for the axle hub runout (See page AH-16). If the bearing play and axle hub runout are normal, adjust the disc runout or grind it on a "On-car" brake lathe.
3. ADJUST PARKING BRAKE SHOE CLEARANCE
4. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
(a) Temporarily install the rear disc brake bleeder plug to the disc brake cylinder assembly rear LH.
5. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
6. INSTALL PISTON SEAL
(a) Apply lithium soap base glycol grease to a new piston seal.
(b) Install the piston seal to the disc brake cylinder assembly rear LH.
7. INSTALL REAR DISC BRAKE PISTON
(a) Apply lithium soap base glycol grease to the rear disc brake piston and new cylinder boot.
(b) Install the cylinder boot to the rear disc brake piston.
(c) Install the rear disc brake piston to the disc brake cylinder assembly rear LH.
NOTICE: Do not install the piston forcibly in the disc brake cylinder.
8. INSTALL CYLINDER BOOT
(a) Install a new cylinder boot to the rear disc brake cylinder sub-assembly.
NOTICE: Install the boot securely to the grooves of the cylinder and piston.
(b) Using a screwdriver, install the set ring.
9. INSTALL REAR DISC BRAKE BUSH DUST BOOT
(a) Install the 2 rear disc brake bush dust boot to the disc brake cylinder mounting LH.
10. INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN
(a) Apply the lithium soap base glycol grease to the sealing surface of the 2 rear disc brake cylinder slide pins.
Operation check
NOTICE: Inspection should be started after conforming that
the items listed in the "CUSTOMIZE PARAMETER" for the power back door system
have defaulted to the initial settings
1. CHECK OPENING OPERATION
Conditions necessary for the power back door to
open:
Power back d ...
Crankshaft Position - Camshaft Position Correlation
DTC P0016 Crankshaft Position - Camshaft Position Correlation
(Bank 1 Sensor A)
DTC P0017 Crankshaft Position - Camshaft Position Correlation
(Bank 1 Sensor B)
DTC P0018 Crankshaft Position - Camshaft Position Correlation
(Bank 2 Sensor A)
DTC P0019 Crankshaft Position - Camshaft Position Corr ...
Inspection
1. INSPECT CRANKSHAFT POSITION SENSOR
Using an ohmmeter, measure the resistance
between the terminals.
Standard resistance
NOTICE:
"Cold" and "Hot" mean the temperature of the
coils themselves.
"Cold" is from -10C (14F) to 50C (122F ...