1. INSTALL MAGNETIC CLUTCH ASSEMBLY
(a) Install the magnetic clutch stator while aligning the protrusion on the stator with the notch on the air compressor assembly as shown in the illustration.
(b) Using a snap ring expander, install a new snap ring with the chamfered side facing up.
NOTICE: Take care not to damage the seal cover of the bearing when installing the snap ring
(c) Install the screw and connect the connector.
(d) Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing up.
NOTICE:
(e) Install the magnet clutch washer and the magnet clutch hub.
NOTICE: Do not change the combination of the magnetic clutch washers used before disassembly.
(f) Using vise pliers, hold the magnetic clutch hub and install the bolt.
Torque: 18 N*m (183 kgf*cm, 13 ft.*lbf)
NOTICE: Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.
Short to GND in Rear Curtain Shield Squib RH
Circuit
DTC B1632/81 Short to GND in Rear Curtain Shield Squib RH
Circuit
DESCRIPTION
The rear curtain shield squib RH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC ...
Removal
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to
prevent the airbag working.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEE ...
Other functions
Switching between outside air and recirculated air modes
Press .
The mode switches between outside air mode (
appears on the
display) and recirculated air mode (
appears on the display) each
time the button is pressed.
Defogging the windshield
Defoggers are used to defog the windshield a ...