Toyota Sienna Service Manual: Reassembly

Toyota Sienna Service Manual / Air conditioning / Integration control and panel / Reassembly

1. INSTALL CENTER CLUSTER MODULE KNOB NO.6 (for Automatic Air Conditioning System)

2. INSTALL CENTER CLUSTER MODULE KNOB NO.5 (for Automatic Air Conditioning System)

3. INSTALL CLOCK ORNAMENT

4. INSTALL PRINTED WIRE INTEGRATION BOARD SUB-ASSEMBLY (for Automatic Air Conditioning System)

5. INSTALL HEATER BLOWER SWITCH (for Manual Air Conditioning System)

6. INSTALL INTEGRATION CONTROL AND PANEL BULB (for Manual Air Conditioning System)

7. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY (for Automatic Air Conditioning System)

8. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY (for Manual Air Conditioning System)

9. INSTALL CENTER CLUSTER MODULE KNOB NO.2 (for Manual Air Conditioning System)

10. INSTALL CENTER CLUSTER MODULE KNOB NO.1 (for Manual Air Conditioning System)

Disassembly

1. REMOVE CENTER CLUSTER MODULE KNOB NO.1 (for Manual Air Conditioning System) (a) Remove the center cluster module knob No. 1. 2. REMOVE CENTER CLUSTER MODULE KNOB NO.2 (for Manual Air Condit ...

Installation

1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY 2. INSTALL RADIO RECEIVER WITH BRACKET (w/ Navigation System) 3. INSTALL RADIO RECEIVER WITH BRACKET (w/o Navigation System) 4. INSTALL INSTRUME ...

Other materials:

On-vehicle inspection
1. FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) Perform a diagnostic system check. With the front seat side airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seatback ass ...

Inspection
1. INSPECT REAR DRIVE SHAFT ASSEMBLY LH (a) Check that there is no remarkable play in the radial direction of the outboard joint. (b) Check that the inboard joint slides smoothly in the thrust direction. (c) Check that there is no remarkable play in the radial direction of the inboard ...

Door control switch
INSPECTION 1. INSPECT DOOR CONTROL SWITCH ASSEMBLY Measure the resistance according to the value(s) in the table below. Standard resistance HINT: If the result is not as specified, replace the switch. ...