Toyota Sienna Service Manual: Reassembly
1. INSTALL LIGHT CONTROL ECU (DISCHARGE HEADLIGHT)
- Install a new headlight leveling motor base packing.
- Install the headlight leveling motor assembly as
shown in the illustration.
- Connect the connector with the claw
- Install the light control ECU with the 2 screws.
- Install a new headlight gasket.
- Install the headlight cover with the 4 screws.
2. INSTALL FRONT SIDE MARKER LIGHT BULB
- Install the side marker light bulb to the side marker
light socket
- Turn in the direction indicated by the arrow and
install the side marker light bulb and side marker
light socket as a unit.
3. INSTALL FRONT TURN SIGNAL LIGHT BULB
- Install the front turn signal light bulb to the front turn
signal light socket.
- Turn in the direction indicated by the arrow and
install the front turn signal light bulb and front turn
signal light socket as a unit.
4. INSTALL NO. 2 HEADLIGHT BULB
- Turn in the direction indicated by the arrow and
install the No.2 headlight bulb.
5. INSTALL DISCHARGE HEADLIGHT BULB (DISCHARGE HEADLIGHT)
- Install the discharge headlight bulb with the set
spring as shown in the illustration.
- Turn in the direction indicated by the arrow and
install the socket.
- Turn in the direction indicated by the arrow and
install the headlight socket cover.
6. INSTALL NO. 1 HEADLIGHT BULB (HALOGEN HEADLIGHT)
- Turn in the direction indicated by the arrow and
install the No.1 headlight bulb.
1. VEHICLE PREPARATION FOR HEADLIGHT AIMING
ADJUSTMENT
Prepare the vehicle:
Ensure there is no damage or deformation to the
body around the headlights.
Fill the fuel t ...
1. INSTALL HEADLIGHT ASSEMBLY
Connect the connectors.
Install the headlight assembly with the bolt and 3
screws.
2. INSTALL FRONT BUMPER ASSEMBLY
3. CONNECT CABLE TO NEGATI ...
Other materials:
Stereo Component Amplifier Power Source Circuit
DESCRIPTION
This circuit provides power to the stereo component amplifier.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT STEREO COMPONENT AMPLIFIER
Disconnect the stereo component amplifier connector.
Measure the resistance according to the value(s) in the
table below.
S ...
Preparation 2gr-fe cooling
SST
RECOMMENDED TOOLS
EQUIPMENT
COOLANT
Capacity
Classification
11.3 liters (12.0 US qts, 10.0 Imp. qts)
Use only "TOYOTA Super Long Life Coolant" or similar high quality
ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate
coolant ...
Power steering fluid
Bleeding
1. BLEED POWER STEERING SYSTEM
(a) Check the fluid level (See page PS-2).
(b) Jack up the front of the vehicle and support it with
stands.
(c) Turn the steering wheel.
(1) With the engine stopped, turn the steering
wheel slowly from lock to lock several times.
(d) Lower the ...