1. INSTALL INSTR PNL PASS L/DOOR AIR BAG ASSEMBLY
2. INSTALL INSTRUMENT PANEL WIRE NO.2
3. INSTALL NAVIGATION ANTENNA ASSEMBLY
4. INSTALL ANTENNA CORD SUB-ASSEMBLY
5. INSTALL INSTRUMENT PANEL BOX DOOR SUBASSEMBLY NO.2
6. INSTALL INSTRUMENT PANEL FINISH PANEL RETAINER NO.1
7. INSTALL INSTRUMENT FINISH PANEL RETAINER LOWER NO.2
8. INSTALL INSTRUMENT FINISH PANEL RETAINER LOWER
9. INSTALL DEFROSTER DUCT BRACKET NO.1
10. INSTALL INSTRUMENT CLUSTER FINISH PANEL REINFORCEMENT
11. INSTALL INSTRUMENT PANEL FINISH PANEL RETAINER LOWER NO.3
12. INSTALL SIDE DEFROSTER NOZZLE RH
13. INSTALL SIDE DEFROSTER NOZZLE LH
14. INSTALL HEATER TO REGISTER DUCT NO.3
15. INSTALL HEATER TO REGISTER DUCT NO.2
16. INSTALL HEATER TO REGISTER DUCT NO.1
17. INSTALL DEFROSTER NOZZLE ASSEMBLY
18. INSTALL SIDE DEFROSTER NOZZLE DUCT NO.2
19. INSTALL SIDE DEFROSTER NOZZLE DUCT NO.1
Data list / active test
1. USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Monitor the ECU data by following the prompts on
the tester screen.
HINT:
The intelligent tester has a "Snapshot" function
which records the monitored data. Refer to the
intelligent tester ope ...
VIN not Programmed or Mismatch - ECM / PCM
DESCRIPTION
DTC P0630 is set when the Vehicle Identification Number (VIN) is not stored
in the Engine Control Module
(ECM) or the input VIN is not accurate. Input the VIN with the intelligent
tester.
MONITOR STRATEGY
TYPICAL ENABLING CONDITIONS
TYPICAL MALFUNCTION THRESHOLDS ...
On-vehicle inspection
1. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY
(VEHICLE NOT INVOLVED IN COLLISION)
Perform a diagnostic system check.
With the front passenger airbag assembly installed
on the vehicle, perform a visual check. If there are
any defects as mentioned below, replace the
instrumen ...