1. INSTALL SEAT POSITION AIRBAG SENSOR (for Driver Seat)
2. INSTALL FRONT SEAT CUSHION SHIELD LOWER LH
3. INSTALL FRONT SEAT CUSHION SHIELD LOWER RH
HINT: Use the same procedures for the RH side and LH side.
4. INSTALL RECLINING ADJUSTER INSIDE COVER LH
5. INSTALL RECLINING ADJUSTER INSIDE COVER RH
HINT: Use the same procedures for the RH side and LH side.
6. INSTALL RECLINING ADJUSTER INSIDE COVER LH
7. INSTALL RECLINING ADJUSTER INSIDE COVER RH
HINT: Use the same procedures for the RH side and LH side.
8. INSTALL FRONT SEATBACK COVER LH
NOTICE:
9. INSTALL SEATBACK COVER WITH PAD
NOTICE:
Torque: 5.5 N*m (56 kgf*cm, 48 in.*lbf)
NOTICE:
NOTICE:
10. INSTALL FRONT SEAT HEADREST SUPPORT
11. INSTALL LUMBAR SUPPORT KNOB LH (for Driver Seat)
12. INSTALL FRONT SEATBACK BOARD LH
13. INSTALL SEAT CUSHION COVER WITH PAD
14. INSTALL FRONT SEAT INNER LH ARMREST ASSEMBLY
Torque: 20 N*m (200 kgf*cm, 14 ft.*lbf)
15. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
NOTICE:
16. INSTALL FRONT SEAT TRACK COVER LH FRONT INNER
17. INSTALL FRONT SEAT TRACK COVER LH FRONT OUTER
18. INSTALL FRONT SEAT CUSHION SHIELD INNER LH
19. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
Torque: 41 N*m (418 kgf*cm, 30 ft.*lbf) HINT: Check that the inner seat belt assembly moves smoothly.
20. INSTALL FRONT SEAT CUSHION SHIELD LH
21. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
22. INSTALL VERTICAL SEAT ADJUSTER KNOB (for Driver Seat)
23. INSTALL OCCUPANT CLASSIFICATION ECU (for Front Passenger Seat)
24. INSTALL FRONT SEAT SIDE TABLE (w/ Table)
Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
25. INSTALL FRONT SEAT SIDE TABLE LEG COVER (w/ Table)
Ignition Coil "A" Primary
HINT:
These DTCs indicate malfunctions relating to the primary circuit.
If DTC P0351 is set, check the No. 1 ignition coil with igniter circuit.
If DTC P0352 is set, check the No. 2 ignition coil with igniter circuit.
If DTC P0353 is set, check the No. 3 ignition coil with igniter circ ...
Current Position Display does not Appear
INSPECTION PROCEDURE
1 CHECK RADIO AND NAVIGATION ASSEMBLY
Check if a map disc is inserted into the map disc slot.
OK:
A map disc is inserted
2 CHECK MAP DISC
Check that the map disc is not deformed or cracked.
OK:
No deformations or cracks appear on the map disc.
PROCEED ...
Fail-safe chart
HINT:
If the following conditions are detected while the cruise
control is in operation, the system clears the stored vehicle
speed in the ECM and cancels the cruise control operation.
Vehicle Condition
Auto Cancel Condition
Re-operation Condition
CRUISE main in ...