1. INSTALL REAR DOOR WIRE SUB-ASSEMBLY LH
NOTICE: When installing the wire, push the areas where the clips are installed in order to prevent damage and deformation.
2. INSTALL REAR DOOR LOCK ASSEMBLY LH
Adhesive: Part No. 08833-00070, THREE BOND 1324 or equivalent
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
3. INSTALL SLIDE DOOR LOCK ASSEMBLY FRONT LH
Adhesive: Part No. 08833-00070, THREE BOND 1324 or equivalent
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
4. INSTALL REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH
Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf) NOTICE: Insert a cover between the nut and the door panel.
If the shift lever cannot
be shifted from P
If the shift lever cannot be shifted with your foot on the brake
pedal, there may be a problem with the shift lock system (a system
to prevent accidental operation of the shift lever). Have the
vehicle inspected by your Toyota dealer immediately.
The following steps may be used as an emergency ...
Short in Front Passenger Side Squib Circuit
DTC B0105/53 Short in Front Passenger Side Squib Circuit
DESCRIPTION
The front passenger side squib circuit consists of the center airbag sensor
assembly and the front
passenger airbag assembly.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0105/53 is re ...
Throttle Actuator Control Motor Current Range / Performance
DESCRIPTION
The ETCS (Electronic Throttle Control System) has a dedicated power supply
circuit. The voltage (+BM)
is monitored and when it is low (less than 4 V), the ECM determines that there
is a malfunction in the
ETCS and cuts off the current to the throttle actuator.
When the volt ...