Toyota Sienna Service Manual: Reassembly
1. INSTALL LH REAR BUMPER SIDE RETAINER
- Install the LH rear bumper side retainer with the 3 screws.
2. INSTALL RH REAR BUMPER SIDE RETAINER
- Install the RH rear bumper side retainer with the 3 screws.
3. INSTALL REAR BUMPER REINFORCEMENT SUBASSEMBLY
- Install the rear bumper reinforcement sub-assembly
with the 6 nuts.
Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)
4. INSTALL REAR BUMPER BAR PLATE
- Install the rear bumper bar plate to the rear bumper reinforcement sub-assembly with the 4 clips.
5. INSTALL REAR BUMPER ENERGY ABSORBER
6. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System) (See page PM-20)
7. INSTALL NO. 1ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)
Disassembly
1. REMOVE NO. 1ULTRASONIC SENSOR RETAINER
(w/ Clearance Sonar System) (See page PM-19)
2. REMOVE NO. 1 ULTRASONIC SENSOR (w/
Clearance Sonar System) (See page PM-19)
3. REMOVE REAR BUMPER ENERGY A ...
Installation
1. INSTALL REAR BUMPER COVER
Install the rear bumper cover with the 2 screws and
8 clips.
...
Other materials:
Unmatched Encryption Code
DTC B2794 Unmatched Encryption Code
DESCRIPTION
This DTC is output when a key with an incomplete key code is inserted into
the ignition key cylinder.
DTC No.
DTC Detection Condition
Trouble Area
B2794
Key with incomplete key code inserted
Key
IN ...
Removal
1. REMOVE REAR WINDOW SIDE GARNISH
ASSEMBLY
2. REMOVE REAR DOOR WINDOW FRAME SUBASSEMBLY
3. REMOVE SIDE TRIM BOARD COVER REAR
4. REMOVE REAR DOOR TRIM BOARD SUBASSEMBLY
5. REMOVE REAR DOOR GLASS RUN
6. REMOVE SLIDE DOOR WINDOW ASSEMBLY
7. REMOVE REAR DOOR GLASS WEATHERSTRIP
Put pro ...
Turbine Speed Sensor Circuit No Signal
DESCRIPTION
This sensor detects the rotation speed of the input turbine. By comparing the
input turbine speed signal
(NT) with the counter gear speed sensor signal (NC), the ECM detects the shift
timing of the gears and
appropriately controls the engine torque and hydraulic pressure accor ...
