Toyota Sienna 2010-2026 Owners Manual: Receiving a call
When a call is received, the following screen is displayed together with a sound.
To answer the phone
Press the 
switch on the steering
wheel or select 
.
To refuse a call
Press the 
switch on the steering
wheel or select 
To adjust the incoming call volume
Turn the “PWR•VOL” knob. You can also adjust the volume using the steering switches.
International calls
Received international calls may not be displayed correctly depending on the cellular phone in use.
Making a call
Once a Bluetooth® phone is registered, you can make a call
using the following procedure:
Dialing
Display the phone screen.
Select the “Dial Pad” tab and enter a phone number.
To delet ...
Speaking on the phone
The following screen is displayed when speaking on the phone.
To adjust the call volume
Select “-” or “+”. You can also adjust the volume using the steering
switches or the volume knob. ...
Other materials:
Radio Receiver Power Source Circuit
DESCRIPTION
This circuit provides power to the radio receiver.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT RADIO RECEIVER ASSEMBLY
Disconnect the radio receiver connector.
Measure the resistance according to the value in the
table below.
Standard resistance
Measure t ...
Network gateway ECU
COMPONENTS
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE LH
2. REMOVE COWL SIDE TRIM BOARD LH
3. REMOVE INSTRUMENT PANEL FINISH PANEL
LOWER LH (See page IP-6)
4. REMOVE INSTRUMENT PANEL SAFETY PAD
INSERT NO. 1 (See page IP-6)
5. REMOVE CLEARANCE WARNING ECU ASSEMBLY
(See page PM-15)
6. REMOVE ...
Seat Belt Buckle Switch LH Circuit Malfunction
DTC B0126/27 Seat Belt Buckle Switch LH Circuit Malfunction
DESCRIPTION
The seat belt buckle switch LH circuit consists of the center airbag sensor
assembly and the front seat
inner belt assembly LH.
DTC B0126/27 is recorded when a malfunction is detected in the seat belt buckle
switch LH ...
