(a) Connect the intelligent tester to DLC3 (Procedure "A").
(b) Turn the ignition switch to the ON position (Procedure "B").
(c) Select the REGIST TIRE following the intelligent tester screen (UTILITY - REGIST TIRE) (Procedure "C").
(d) Input the IDs (ID1 to ID4) using the intelligent tester and transmit them to the tire pressure warning ECU (Procedure "D").
(e) Set the ID transmission condition to "ID Registration is complete" (Procedure "E").
HINT:
If you have a flat tire
(vehicles with
run-flat tires)
Your vehicle is not equipped with a spare tire, but instead you
can continue driving the vehicle with run-flat tires even if any
tire goes flat.
In this case, slow down and drive with extra caution.
Run-flat tires (A “RFT” or “DSST” mark is molded on the sidewall)
Take your vehicle to ...
Suspension
SERVICE DATA
A: Ground clearance of front wheel center
B: Ground clearance of lower suspension arm No. 2 set bolt
center
C: Ground clearance of rear axle carrier bush set bolt center
D: Ground clearance of rear wheel center
TORQUE SPECIFICATIONS
TIRE AND WHEEL
SERVICE DATA
T ...
Short to GND in Curtain Shield Squib LH Circuit
DTC B1167/85 Short to GND in Curtain Shield Squib LH Circuit
DESCRIPTION
The curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain shield
airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1167/85 is ...