Toyota RAV4 manuals

Toyota Sienna Service Manual: Registration

NOTICE:

The Vehicle Identification Number (VIN) must be input into the replacement ECM.

HINT:

The VIN is a 17-digit alphanumeric vehicle identification number. The intelligent tester is required to register the VIN.

Basic inspection
When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic ...

Input instructions
(a) The general VIN input instructions using the intelligent tester are shown below: (b) The arrow buttons (UP, DOWN, RIGHT and LEFT) and numerical buttons (0 to 9) are used to input the VIN. ( ...

Other materials:

A/F sensor and ho2s monitors
(a) Preconditions The monitor will not run unless: 2 minutes or more have elapsed since the engine was started. The Engine Coolant Temperature (ECT) is 75°C (167°F) or more. Cumulative driving time at a vehicle speed of 30 mph (48 km/h) or more exceeds 6 minutes. Air-fuel ratio fe ...

Television display
COMPONENTS Removal 1. REMOVE TELEVISION BASE  Release the 4 clips and remove the television base. 2. REMOVE TELEVISION DISPLAY ASSEMBLY  Disconnect the connector and remove the 4 bolts and the television display assembly. Installation 1. INSTALL TELEVISION DISP ...

Open in Occupant Classification ECU Battery Positive Line
DTC B1794 Open in Occupant Classification ECU Battery Positive Line DESCRIPTION This circuit consists of the occupant classification ECU and the power source circuit (battery, fuse, wire harness). DTC B1794 is recorded when a malfunction is detected in the occupant classification ECU or t ...

© 2011-2024 Copyright www.tsienna.net