Toyota Sienna Service Manual: Release Actuator Circuit
DESCRIPTION
The fold seat control ECU receives a switch operation signal from the fold seat switch and activates the release actuator. The release actuator releases the lock of the stowed seat based on a drive voltage received from the ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FOLD SEAT CONTROL ECU
- Remove the fold seat control ECU with connector still connected.
- Measure the voltage according to the value(s) in the table below.
Standard voltage LH side
RH side
2 CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - FOLDING MOTOR)
- Disconnect the connectors from the fold seat control ECU.
- Disconnect the connector from the folding motor.
- Measure the resistance according to the value(s) in the table below.
Standard resistance LH side
RH sid
3 CHECK HARNESS AND CONNECTOR (FOLDING MOTOR - BODY GROUND)
- Measure the resistance according to the value(s) in the table below.
Standard resistance LH side
RH side
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Reclining Motor Circuit
DESCRIPTION
The fold seat control ECU receives a switch operation signal from the power
rear no. 2 seat switch and
the fold seat switch, and activates the reclining motor. At this time, the Hall
...
Lock Switch Circuit
DESCRIPTION
Each of the left and right seats has lock switches that detect the lock
condition of the seat legs to the floor
when the seat is in the original or folded-down state. If any of the loc ...
Other materials:
DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER)
Checking DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Read DTCs by following the prompts on the
tester screen.
HINT:
Refer to the intelligent tester operator's manual
for further details.
2. CLEAR DTC ...
Front Occupant Classification Sensor RH Collision
Detection
DTC B1786 Front Occupant Classification Sensor RH Collision
Detection
DESCRIPTION
DTC B1786 is output when the occupant classification ECU receives a collision
detection signal sent by
the front occupant classification sensor RH if an accident occurs.
DTC B1786 is also output when the front ...
Diagnosis system
1. CHECK DLC3
The ECU uses ISO 15765-4 for communication.
The terminal arrangement of the DLC3 complies
with SAE J1962 and meets the ISO 15765-4 format.
NOTICE:
*: Before measuring the resistance, leave the
vehicle as is for at least 1 minute and do not
operate the ignition s ...
