Retract the belt slowly when releasing and stowing the seat belt.
Dtc check / clear
1. DTC CHECK (SENSOR CHECK)
(a) After the indicator check is completed, the system
enters the DTC check mode automatically.
(b) Read the codes displayed on the panel. Refer to the
list of codes (See page AC-19) when reading the
codes. (Trouble codes are output at the temperature
display. ...
Rear Occupant Classification Sensor RH Collision
Detection
DTC B1788 Rear Occupant Classification Sensor RH Collision
Detection
DESCRIPTION
DTC B1788 is output when the occupant classification ECU receives a collision
detection signal sent by
the rear occupant classification sensor RH if an accident occurs.
DTC B1788 is also output when the front s ...
Removal
1. REMOVE OUTSIDE MOULDING
Put protective tape around the outside moulding.
Using a heat light, heat the moulding between 40 to
60 C (104 to 140 F).
NOTICE:
Do not heat the moulding excessively.
Tie both piano wire ends to a wooden block or a
similar object.
Cut off the tape by ...