1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
HINT: (See page EX-8)
2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
HINT: (See page PR-3)
3. REMOVE REAR DIFFERENTIAL FILLER PLUG
(a) Using a hexagon wrench (10 mm), remove the filler plug and gasket.
4. REMOVE REAR DIFFERENTIAL DRAIN PLUG
(a) Using a hexagon wrench (10 mm), remove the drain plug and gasket, and drain the oil.
5. REMOVE REAR DRIVE PINION NUT
(a) Using a chisel and a hammer, unstake the staked part of the nut.
(b) Using SST to hold the flange, remove the nut.
SST 09330-00021
6. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY
(a) Using SST, remove the companion flange.
SST 09950-30012 (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03020)
7. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL
(a) Using SST, remove the oil seal.
SST 09308-10010
8. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER
9. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING
(a) Using SST, remove the front tapered roller bearing.
SST 09556-22010
10. REMOVE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER
U151e automatic transaxle
SERVICE DATA
TORQUE SPECIFICATIONS
...
Compressor Solenoid Circuit
DESCRIPTION
In this circuit, the compressor receives a refrigerant compression demand
signal from the A/C amplifier.
Based on this signal, the compressor changes the amount of compressor output.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT A/C COMPRESSOR
(a) Disconnect the A/C com ...
Idle Control System Malfunction
DTC P0505 Idle Control System Malfunction
DESCRIPTION
The idling speed is controlled by the ETCS (Electronic Throttle Control
System). The ETCS is comprised
of: 1) the one valve type throttle body; 2) the throttle actuator, which
operates the throttle valve; 3) the
Throttle Position (TP) sen ...