1. Remove rear wheel
2. Remove exhaust pipe assembly
Hint: (see page ex-8)
3. Remove propeller with center bearing shaft assembly
Hint: (see page pr-3)
4. REMOVE REAR DIFFERENTIAL FILLER PLUG
(A) using a hexagon wrench (10 mm), remove the filler plug and gasket.
5. Remove rear differential drain plug
(A) using a hexagon wrench (10 mm), remove the drain plug and gasket, and drain the oil.
6. Remove rear speed sensor lh
Hint: removal procedure or rh side is the same as that or lh side. (See page ds-21)
7. Remove rear axle shaft nut lh
Hint: removal procedure or rh side is the same as that or lh side. (See page ds-21)
8. REMOVE REAR DRIVE SHAFT ASSEMBLY LH
Hint: removal procedure or rh side is the same as that or lh side. (See page ds-21)
9. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
(A) support the rear differential carrier assembly with a jack.
(b) Remove the bolt and nut, separate the No. 1 rear differential support.
(c) Remove the 2 bolts, separate the rear differential support assembly.
NOTICE: Be careful not to drop the rear differential carrier assembly.
10. REMOVE REAR DIFFERENTIAL SUPPORT ASSEMBLY
(a) Remove the 3 bolts and rear differential support assembly.
11. REMOVE REAR DIFFERENTIAL DYNAMIC DAMPER
(a) Remove the 2 bolts and rear differential dynamic damper from the No. 1 rear differential support.
12. REMOVE NO. 1 REAR DIFFERENTIAL SUPPORT
(a) Remove the 2 bolts, 2 nuts and No. 1 rear differential support.
Mute Signal Circuit between Radio Receiver and Television Display
Assembly
DESCRIPTION
The radio receiver controls the volume according to the MUTE signal from the
television display
assembly.
The MUTE signal is sent to reduce noise and a popping sound generated when
switching the mode, etc.
If there is an open in the circuit, noise can be heard from the speake ...
No Sound can be Heard from Speakers
INSPECTION PROCEDURE
1 CHECK AUDIO SETTINGS
Enter the sound adjustment screen by pressing the
"SOUND" switch on the AUDIO display.
Set volume, fader, and balance to the initial values and
check that sound is normal.
OK:
Audio system returns to normal.
HINT:
Sou ...
Reassembly
1. APPLY HIGH TEMPERATURE GREASE
(a) Apply the high temperature grease to the surface on
which the shoe and backing plate attach.
2. INSTALL PARKING BRAKE SHOE LEVER LH
(a) Install the shoe lever and shim to the rear shoe with
a new C-washer.
(b) Using a feeler gauge, measure the clearance.
...