1. REMOVE REAR WHEEL
2. REMOVE EXHAUST PIPE ASSEMBLY
HINT: Perform this procedure only when removing the RH side.
(See page EX-8)
3. REMOVE REAR SPEED SENSOR LH
HINT: (See page DS-21)
4. REMOVE REAR AXLE SHAFT NUT LH
HINT: (See page DS-21)
5. REMOVE REAR DRIVE SHAFT ASSEMBLY LH
HINT: (See page DS-21)
6. REMOVE REAR DIFFERENTIAL SIDE GEAR SHAFT BOLT
(a) Using SST and wood block, remove the rear differential side gear shaft bolt.
SST 09611-12010
Check for intermittent problems
1. CHECK FOR INTERMITTENT PROBLEMS
HINT:
For use of the intelligent tester only:
Inspect the vehicle's ECM using check mode.
Intermittent problems are easier to detect with an
intelligent tester when the ECM is in check mode. In
check mode, the ECM uses 1 trip detection logic, which
is more ...
Stereo component speaker
COMPONENTS
ON-VEHICLE INSPECTION
1. INSPECT STEREO COMPONENT SPEAKER
HINT:
Remove interior parts so that the stereo component
speaker can be seen.
Check the speaker installation.
OK:
The speaker is securely installed.
If the result is not as specified, reinstall the stereo ...
Clock setting
Display the “General Settings” screen.
Operations up to this point can also be performed by select the clock
display
at the top of most screens.
Select the items to be set.
Manual clock setting
Set minutes to 00
The 24-hour time format can
be to on/off.
Select ...