Toyota RAV4 manuals

Toyota Sienna Service Manual: Removal

HINT: Replace the RH side by the same procedures as the LH side.

1. REMOVE REAR WHEEL

2. REMOVE REAR AXLE SHAFT LH NUT (See page DS- 22)

3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH

(a) Removing the 2 bolts, separate the rear disc brake caliper assembly LH.

4. REMOVE REAR DISC

5. SEPARATE SPEED SENSOR REAR LH

(a) Removing the bolt, separate the speed sensor rear LH.

NOTICE:

6. REMOVE REAR DRIVE SHAFT ASSEMBLY LH (See page DS-22)

7. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH

REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH

(a) Remove the 4 bolts and hub & bearing assembly LH.

On-vehicle inspection
1. INSPECT REAR AXLE HUB BEARING BACKLASH (a) Using a dial gauge, check for backlash near the center of the axle hub. Maximum: 0.05 mm (0.0020 in.) If backlash exceeds the maximum, replace th ...

Installation
1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH (a) Install the hub & bearing assembly LH with the 4 bolts. Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf) 2. INSPECT BEARING BACKLASH (See page ...

Other materials:

Customize parameters
HINT: The following items can be customized. NOTICE:  After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.  Be sure to record the current settings before customization.  When troubleshooti ...

SRS airbags
The SRS airbags inflate when the vehicle is subjected to certain types of severe impacts that may cause significant injury to the occupants. They work together with the seat belts to help reduce the risk of death or serious injury. SRS front airbags SRS driver airbag/front passenger ...

Installation
1. INSTALL ROOF HEADLINING ASSEMBLY w/ sliding roof: Install the roof headlining with the 5 clips. w/o sliding roof: Install the roof headlining with the 3 clips. NOTICE: In order to prevent the roof headlining from becoming bent, work must be performed by 2 or more persons when ...

В© 2011-2024 Copyright www.tsienna.net