Toyota Sienna Service Manual: Removal
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
HINT: (See page EM-34)
2. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR
(a) Remove the 3 nuts and transverse engine engine mounting insulator.
3. REMOVE FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH
(a) Remove the 2 bolts on the front side of the front suspension arm sub-assembly lower No.1 LH.
(b) Remove the bolt and nut on the rear side of the front suspension arm sub-assembly lower No.1 LH.
(c) Remove the front suspension arm sub-assembly lower No.1 LH.
(d) Remove the front lower arm bush stopper from the front suspension arm sub-assembly lower No.1 LH.
Front lower suspension arm
Components
...
Installation
1. INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH
(a) Install the front lower arm bush stopper to the front
suspension arm sub-assembly lower No.1 LH.
(b) Install the bolt and nut to ...
Other materials:
System description
1. Radio and navigation assembly outline
Conventionally, 2 separate devices, a "radio and
display" and a "navigation ECU" are used. This
model has adopted a new type, combining these
devices into a single unit.
2. Navigation system outline
Vehicle ...
Stereo Component Amplifier Communication Error
INSPECTION PROCEDURE
1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor"
mode.
Identify the component shown by the sub-code.
HINT:
"110 (multi-display)" i ...
Short to GND in Front Passenger Side Squib
Circuit
DTC B0107/51 Short to GND in Front Passenger Side Squib
Circuit
DESCRIPTION
The front passenger side squib circuit consists of the center airbag sensor
assembly and the front
passenger airbag assembly.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0107/ ...
