HINT: Remove the RH side by the same procedure as the LH side.
1. REMOVE REAR WHEEL
2. REMOVE QUARTER TRIM PANEL ASSEMBLY FRONT LH
HINT: Remove the LH side by the same procedure as the RH side (See page IR-9).
3. REMOVE REAR SPEED SENSOR
(a) Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.
(b) Remove the clamp bolt holding the sensor harness from the body.
(c) Remove the bolt and speed sensor rear LH.
NOTICE: Keep the tip of the speed sensor rear LH clean.
Capacity and distribution
Cargo capacity depends on the total weight of the occupants.
(Cargo capacity) = (Total load capacity) - (Total weight of occupants)
Steps for Determining Correct Load Limit
Locate the statement “The combined weight of occupants and
cargo should never exceed XXX kg or XXX lbs.” on your ...
Transfer
SST
RECOMMENDED TOOLS
EQUIPMENT
LUBRICANT
SSM
...
Terminals of ECU
1. CHECK DISTANCE CONTROL ECU
Reference: waveform 1
HINT:
Terminal: LRDD - SGND
Gauge set: 2 V/DIV., 10 ms./DIV.
Condition: ignition switch in the ON position
Reference: waveform 2
HINT:
Terminal: LRRD - SGND
Gauge set: 2 V/ ...