Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Brake control / Steering angle sensor / Removal

1. PRECAUTION

HINT: See page RS-1

2. SEPARATE BATTERY NEGATIVE TERMINAL

3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

4. REMOVE HORN BUTTON ASSEMBLY (See page RS- 424)

5. REMOVE STEERING WHEEL ASSEMBLY (See page SR-6)

6. REMOVE STEERING COLUMN COVER LWR (See page RS-434)

7. REMOVE SPIRAL CABLE SUB-ASSEMBLY (See page RS-434)

8. REMOVE STEERING ANGLE SENSOR

REMOVE STEERING ANGLE SENSOR

(a) Release the claw fittings and remove the steering sensor from the spiral cable.

Installation

1. INSTALL STEERING ANGLE SENSOR (a) Install the steering sensor onto the spiral cable. 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (See page RS-434) 4. I ...

Other materials:

Installation
1. INSTALL OCCUPANT CLASSIFICATION ECU Check that the ignition switch is off. Check that the negative battery (-) terminal is disconnected. CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation. &nbs ...

Making a call
Once a Bluetooth® phone is registered, you can make a call using the following procedure: Dialing Display the phone screen. Select the “Dial Pad” tab and enter a phone number. To delete the input phone number, select . For the first digit, you can enter “+” by selecting “&# ...

Meter Illumination is Always Dark
DESCRIPTION Confirm that the vehicle is equipped with the optitron meter, then check this circuit. The combination meter assembly receives a auto dimmer signal from the body ECU by the multiplex communication line. WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK MULTIPLEX CO ...