Toyota Sienna Service Manual: Removal
NOTICE: When installing, coat the parts indicated by the arrows with power steering fluid or molybdenum disulfide lithium base grease (See page PS-21).
1. INSPECT CENTER FRONT WHEEL
2. REMOVE FRONT WHEEL
3. SEPARATE TIE ROD ASSEMBLY LH SST 09628-62011
4. SEPARATE TIE ROD ASSEMBLY RH SST 09628-62011
HINT: Perform the same procedure on the other side.
5. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) Fix the steering wheel with the seat belt.
(b) Release the 3 springs and separate the dust cover.
(c) Place matchmarks on the intermediate shaft assembly and power steering gear assembly.
(d) Remove the bolt and separate the intermediate shaft assembly.
6. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH
7. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure on the other side.
8. REMOVE FRONT STABILIZER BRACKET NO.1 LH
(a) Remove the 2 bolts and remove the stabilizer bracket No. 1.
9. REMOVE FRONT STABILIZER BRACKET NO.1 RH
HINT: Perform the same procedure on the other side.
10. DISCONNECT PRESSURE FEED TUBE ASSEMBLY
(a) Remove the clip and disconnect the return tube assembly from the power steering gear assembly.
(b) Using SST, disconnect the pressure feed tube assembly from the power steering gear assembly.
SST 09023-12701
(c) Remove the bolt and separate the tube clamp.
(d) Remove the nut and separate the tube clamp.
11. REMOVE RACK & PINION POWER STEERING GEAR ASSEMBLY
(a) Remove the 2 bolts, nuts and the power steering gear assembly.
NOTICE: Do not damage the 2 pressure tubes.
Rack and pinion power steering gear
COMPONENTS
...
Disassembly
1. REMOVE RETURN TUBE NO.2
(a) Using SST, remove the return tube No. 2.
SST 09023-12701
2. REMOVE STEERING LEFT TURN PRESSURE TUBE
(a) Using SST, remove the left turn pressure tube.
S ...
Other materials:
Installation
1. INSTALL REAR DOOR GLASS WEATHERSTRIP
Install the rear door glass weatherstrip.
2. INSTALL SLIDE DOOR WINDOW ASSEMBLY
3. INSTALL REAR DOOR GLASS RUN
4. INSTALL REAR DOOR TRIM BOARD SUBASSEMBLY
5. INSTALL SIDE TRIM BOARD COVER REAR
6. INSTALL REAR DOOR WINDOW FRAME SUBASSEMBLY
7. INSTA ...
ABS Warning Light does not Come ON
WIRING DIAGRAM
See page BC-47.
INSPECTION PROCEDURE
1 INSPECT ABS WARNING LIGHT
(a) Disconnect the skid control ECU connector.
(b) Turn the ignition switch to the ON position.
(c) Check that the ABS warning light comes on.
OK:
ABS warning light comes on.
HINT:
If troubleshooting has be ...
Diagnostic trouble code chart
1. DTCS FOR OCCUPANT CLASSIFICATION SYSTEM
If a trouble code is displayed during the DTC check,
check the circuit listed for the code in the table below
(proceed to the page listed for that circuit).
HINT:
When DTC B1150/23 is detected as a result of
troubleshooting for the airbag system, pe ...
