Toyota Sienna Service Manual: Removal
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (See page AC-172)
2. REMOVE NO. 2 AIR CLEANER INLET (See page EM- 28)
3. REMOVE FRONT BUMPER ASSEMBLY (See page ET-3)
4. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
(a) Remove the bolt and disconnect the discharge hose sub-assembly from the cooler condenser core.
(b) Remove the O-ring from the discharge hose subassembly.
NOTICE: Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
5. DISCONNECT COOLER REFRIGERANT LIQUID PIPE A
(a) Remove the bolt and disconnect the cooler refrigerant liquid pipe A from the cooler condenser core.
(b) Remove the O-ring from the cooler refrigerant liquid pipe A.
NOTICE: Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
6. REMOVE NO. 1 AIR CLEANER INLET (See page EM- 28)
7. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR (See page CO-29)
8. REMOVE HOOD LOCK ASSEMBLY (See page CO-29)
9. REMOVE HOOD LOCK SUPPORT SUB-ASSEMBLY (See page CO-29)
10. DISCONNECT COOLING FAN ECU CONNECTOR (See page CO-30)
11. REMOVE UPPER RADIATOR SUPPORT SUBASSEMBLY (See page CO-30)
12. DISCONNECT NO. 2 OIL COOLER OUTLET TUBE SUB-ASSEMBLY
(a) Remove the 2 bolts and No. 2 oil cooler outlet tube sub-assembly.
13. REMOVE RADIATOR SUPPORT CUSHION (See page CO-32)
14. REMOVE NO. 1 RADIATOR SUPPORT (See page CO- 32)
15. REMOVE COOLER CONDENSER CORE
(a) Remove the 2 screws and cooler condenser core.
On-vehicle inspection
1. INSPECT COOLER CONDENSER CORE
(a) If the fin of the cooler condenser core is dirty, clean
it with water and dry it with compressed air.
NOTICE:
Do not damage the fin of the cooler condenser
co ...
Disassembly
1. REMOVE COOLER DRYER
(a) Using a hexagon wrench 14 mm (0.55 in.), remove
the cap from the modulator.
(b) Remove the O-ring from the cap.
(c) Using needle nose pliers, remove the cool ...
Other materials:
Precaution
1. PRECAUTION OF HEADLIGHT BULB
REPLACEMENT
When any defects such as deformation, crack, dent,
chipping, etc. are identified on the discharge
headlight (especially, on the light control ECU),
replace it with a new one.
Even if the operation seems to be normal, the failsafe
...
Fastening the seat belt (for the third center seat)
Take the plate out of the holder,
and then pull down the seat
belt.
Push plate “A” into buckle “A”
until a click sound is heard.
Push plate “B” into buckle “B”
until a click sound is heard.
...
Front wheel alignment
Adjustment
NOTICE:
For vehicles equipped with VSC, if wheel alignment has
been adjusted, and if suspension or underbody
components have been removed/installed or replaced, be
sure to perform the following initialization procedure in
order for the system to function normally:
1. Disconnect the ...
