1. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER NO.1 (See page IP-8)
2. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER NO.2
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
HINT: (See page AX-146 for U151E, AX-146 for U151F)
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER (See page IP-9)
5. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH (See page IP-9)
6. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System) (See page AV- 169)
7. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
8. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
(a) Remove the 4 screws, and release the integration control & panel assembly.
(b) Disconnect the connectors and remove the integration control & panel assembly.
Driving position memory
Your preferred driving position (the position of the driver’s seat and
outside rear view mirrors) can be recalled by pressing a button.
Two different driving positions can be recorded into memory.
Recording procedure
Check that the shift lever is in P.
Turn the engine switch to IGNI ...
Reassembly
1. INSTALL MAGNETIC CLUTCH ASSEMBLY
(a) Install the magnetic clutch stator while aligning the
protrusion on the stator with the notch on the air
compressor assembly as shown in the illustration.
(b) Using a snap ring expander, install a new snap ring
with the chamfered side facing up.
...
Remote Up / Down Function does not Operate
DESCRIPTION
If the REMOTE UP/DOWN function does not operate, any of the following
troubles may be the cause:
There is an open or short circuit in the wiring between the power
window master switch and the
applicable power window regulator switch.
The power window master swit ...