Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Supplemental restraint system / Rear airbag sensor / Removal

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE REAR DOOR SCUFF PLATE RH

4. REMOVE REAR DOOR WEATHERSTRIP RH

5. REMOVE BACK DOOR WEATHERSTRIP

6. REMOVE BACK DOOR SCUFF PLATE

7. REMOVE LAP BELT OUTER ANCHOR COVER

8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

9. REMOVE AIR DUCT ASSEMBLY

Remove the screw and the air duct assembly.

10. REMOVE REAR AIRBAG SENSOR LH

REMOVE REAR AIRBAG SENSOR LH

Disconnect the connector from the rear airbag sensor LH.
Remove the 2 bolts and the rear airbag sensor LH.

On-vehicle inspection

1. INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION) Perform a diagnostic system check. 2. INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEP ...

Installation

HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. INSTALL REAR AIRBAG SENSOR LH Check that the ignition ...

Other materials:

Summary of functions
Dynamic radar cruise control supplements conventional cruise control with a vehicle-to-vehicle distance control. In vehicle-to-vehicle distance control mode, the vehicle automatically accelerates or decelerates in order to maintain a set following distance from vehicles ahead. Multi-infor ...

Reassembly
1. INSTALL COOLER DRYER (a) Using needle nose pliers, install the cooler dryer. (b) Install a new O-ring on the cap. (c) Sufficiently apply compressor oil to the fitting surfaces of the O-ring and the cap. Compressor oil: ND-OIL 8 or equivalent (d) Using a hexagon wrench 14 mm ( ...

Changing shift ranges in S mode
To enter S mode, shift the shift lever to S. Shift ranges can be selected by operating the shift lever, allowing you to drive in the shift range of your choosing. The shift range can be selected by the shift lever. Upshifting Downshifting The selected shift range, from 1 to 6, will b ...