Toyota Sienna Service Manual: Removal
1. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for center seat).
- Remove the bolt and rear seat 3 point type belt assembly.
2. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for captain seat type).
- Remove the bolt and rear seat 3 point type belt assembly.
3. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY
HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type RH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type RH side).
- Remove the bolt and rear seat 3 point type belt assembly.
4. REMOVE REAR SEAT INNER BELT ASSEMBLY HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Remove the bolt and rear seat inner belt assembly.
Rear seat inner belt assembly
COMPONENTS
...
Installation
1. INSTALL REAR SEAT 3 POINT TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear
No. 1 seat assembly (for center seat).
Install the rear seat ...
Other materials:
Adjustment
1. VEHICLE PREPARATION FOR FOG LIGHT AIMING
Prepare the vehicle:
Ensure there is no damage or deformation to the
body around the fog lights.
Fill the fuel tank.
Make sure that the oil is filled to the specified
level.
Make sure that the coolant is fi ...
Canceling and resuming the constant speed control
Pulling the lever toward you
cancels the constant speed
control.
The speed setting is also canceled
when the brakes are applied.
Pushing the lever up resumes
the constant speed control.
Resuming is available when the
vehicle speed is more than approximately
25 mph (40 km/h). ...
Initialization
NOTICE:
Resetting the power window motor (initializing the
pulse sensor) is necessary when the battery terminal
is disconnected; when the master switch, wire
harness, power window regulator and power window
motor are replaced or removed/installed; or when the
fuses are replaced. ...
