Toyota Sienna Service Manual: Removal
1. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No .1 seat assembly (for center seat).
- Remove the rear seatback board.
- Remove the rear seat shoulder belt cover.
- Remove the 2 bolts, 2 nuts and No. 1 rear seat outer belt assembly.
2. REMOVE 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
- Remove the roof headlining.
HINT: Refer to the instructions for removal of the roof headlining.
- Remove the 2 bolts, 2 nuts and 3 point type No. 2 rear seat belt assembly.
Rear center seat outer belt assembly
COMPONENTS
...
Installation
1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
Check the degree of tilt when the belt begins to lock
the ELR.
Check that the belt does not lock within 15 of
tilt in all ...
Other materials:
Installation
1. INSTALL FRONT DOOR WINDOW FRAME MOULDING
Remove the tape from the front door window frame
moulding.
Clean the contact surface of the vehicle body with
white gasoline.
Clean the outer circumference of the front door
window frame moulding with white gasoline.
Apply new double-si ...
Installation
1. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING
(a) Install the front shock absorber with coil spring as
shown in the illustration.
(b) Install the 3 nuts to the upper side of the front shock
absorber with coil spring.
Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf)
(c) Install the 2 bolt ...
Removal
1. REMOVE ROOF DRIP SIDE FINISH MOULDING
Put protective tape around the roof drip side finish
moulding.
Using a remover for the roof moulding, disengage of
the clips both in the front and rear ends of the roof
drip side finish moulding and then remove the roof
drip side finish moul ...
