Toyota Sienna Service Manual: Removal
1. REMOVE FRONT WIPER ARM HEAD CAP
- Using a small screwdriver, remove the 2 front wiper arm covers.
HINT: Tape up the screwdriver tip before use.
2. REMOVE FR WIPER ARM RH
- Operate the wiper, and stop the windshield wiper motor assembly to the automatic stop position.
- Remove the nut and the FR wiper arm RH.
3. REMOVE FR WIPER ARM LH
- Remove the nut and the FR wiper arm LH.
4. REMOVE COWL TOP VENTILATOR LOUVER SUBASSEMBLY
- Remove the 6 claws and the cowl top ventilator louver sub-assembly.
5. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
- Disconnect the connector.
- Remove the 4 bolts and wiper motor & link assembly.
6. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
- Using a screwdriver, disengage the meshing of rod at the crank arm pivot of the windshield wiper motor assembly.
- Remove the 3 bolts and windshield wiper motor assembly from the windshield wiper link assembly.
HINT: Turning the crank arm by hand prior to the operation will be able to remove the wiper motor easier.
Front wiper motor
COMPONENTS
...
Inspection
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
LO Operation Check
Connect the battery (+) to the terminal 1 (+1) of
the connector, the battery (-) to the terminal 5
(E) of th ...
Other materials:
Disassembly
1. INSPECT PACK CLEARANCE OF FORWARD
CLUTCH
HINT:
(See page AX-242)
2. REMOVE FORWARD MULTIPLE DISC CLUTCH DISC
(a) Using a screwdriver, remove the snap ring.
(b) Remove the flange, 5 discs and 5 plates from the
input shaft assembly.
3. REMOVE FORWARD CLUTCH RETURN SPRING
SUB-ASSEMB ...
Installation
HINT:
Install the RH side by same procedure as the LH side.
1. INSTALL REAR SPEED SENSOR
(a) Install the speed sensor rear LH with the bolt.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTICE:
Keep the tip of the speed sensor rear LH clean.
(b) Install the sensor harness clamps with the b ...
Open in Front Pretensioner Squib LH Circuit
DTC B0136/74 Open in Front Pretensioner Squib LH Circuit
DESCRIPTION
The front pretensioner squib LH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0136/74 i ...
