Toyota Sienna Service Manual: Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE STEERING WHEEL NO. 2 LOWER COVER
3. REMOVE STEERING WHEEL NO. 3 LOWER COVER
4. REMOVE HONE BUTTON ASSEMBLY
5. REMOVE STEERING PAD SWITCH LH
- Disconnect the connector.
- Disconnect the connector of cruise control main switch.
- Remove the screw.
- w/o Laser radar cruise control:
- Release the 2 pin fittings and remove the steering pad switch LH.
- w/ Laser radar cruise control:
- Remove the clamp.
- w/ Laser radar cruise control:
- Release the 2 pin fittings and release the steering pad switch LH from steering wheel.
- w/ Laser radar cruise control:
- Release the tab of steering pad switch cable from steering pad switch LH as shown in the illustration.
- w/ Laser radar cruise control:
- Disengage the 2 claws as shown in the illustration and open the latch on the top of the connector.
- w/ Laser radar cruise control:
- Pull out the connector while pinching the latch with fingers and disconnect the steering pad switch cable from the steering pad switch LH.
Steering pad switch
COMPONENTS
...
Inspection
1. INSPECT STEERING PAD SWITCH LH (w/o
Navigation System)
Measure the resistance according to the values in
the table below.
Standard resistan
If the result is not as specifie ...
Other materials:
Dtc check / clear
Notice:All the stored dtcs and freeze frame data are
erased if:
1) the ecm is changed from normal mode to check mode
or vice versa; or 2) the ignition switch is turned from on
to acc or off while in check mode.
Before changing modes, always check and make a note
of any dt ...
Data list / active test
1. READ DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows switch,
actuator and other item values to be read without
removing any parts. Reading the DATA LIST early in
troubleshooting is one way to save time.
Connect the intelligent tester with CAN VIM to the
DLC3.
&n ...
Disassembly
1. REMOVE 2ND BRAKE PISTON RETURN SPRING
SUB-ASSEMBLY
(a) Place SST on the return spring and compress the
return spring with a press.
SST 09387-00060
(b) Using a screwdriver, remove the snap ring.
(c) Remove the 2nd brake piston return spring.
2. REMOVE 2ND BRAKE PISTON
(a) Hold ...
