Toyota Sienna Service Manual: Removal
1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
2. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY
3. DRAIN ENGINE COOLANT
4. REMOVE V-BANK COVER SUB-ASSEMBLY
5. REMOVE NO. 2 AIR CLEANER INLET
6. REMOVE NO. 1 AIR CLEANER INLET
7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
- Disconnect the 3 vacuum hoses.
- Remove the No. 2 ventilation hose and air cleaner hose band.
- Disconnect the vacuum hose (EVAP) from the air cleaner hose.
- Disconnect the mass air flow meter connector.
- Remove the 2 bolts and air cleaner cap subassembly.
8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
9. REMOVE THROTTLE BODY
- Disconnect the throttle body connector and clamp.
- Disconnect the 2 water by-pass hoses from the throttle body.
- Remove the 4 bolts and throttle body.
- Remove the throttle body gasket from the intake air surge tank.
On-vehicle inspection
1. INSPECT THROTTLE BODY
Listen to the throttle control motor operating sounds.
Turn the ignition switch to the ON position.
When pressing the accelerator pedal position
sens ...
Inspection
1. INSPECT THROTTLE BODY
Using an ohmmeter, measure the resistance
between the terminals.
Standard resistance
If the result is not as specified, replace the throttle
body asse ...
Other materials:
Initialization
1. ZERO POINT CALIBRATION
NOTICE:
Make sure that the front passenger seat is not
occupied before performing the operation.
HINT:
Perform the zero point calibration and sensitivity check if
any of the following conditions occur.
The occupant classification ECU is replaced.
Acc ...
Power steering
Sst
Recommended tools
EQUIPMENT
LUBRICANT
SSM
...
Removal
1. REMOVE EXHAUST PIPE ASSEMBLY
(a) Remove exhaust pipe assembly (See page EX-8).
2. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(a) Depress the brake pedal and hold it down.
(b) Using a hexagon wrench (6 mm), loosen the cross
groove joint set bolts a half turn.
HINT:
Place a cloth ...
