Toyota Sienna Service Manual: Removal
1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
- Push the right side wall and then push the left wall to release the stoppers.
- Pull the glove compartment door sub-assembly rearward to remove it.
2. REMOVE NO. 2 INSTRUMENT PANEL BOX
- Disengage the 2 claws and 4 clips, and remove the No. 2 instrument panel box.
3. REMOVE ECM
- Disconnect the 5 ECM connectors.
- Remove the 2 nuts and ECM.
4. REMOVE ECM (with 10 speakers system)
- Disconnect the 5 ECM connectors and 2 stereo components amplifier connectors.
- Remove the 4 nuts and the ECM with the stereo components amplifier.
ECM
Components
...
Installation
1. INSTALL ECM
Install the ECM with the 2 nuts.
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
Connect the 5 ECM connectors.
2. INSTALL ECM (with 10 speakers system)
...
Other materials:
Inspection
1. INSPECT MASS AIR FLOW METER
Visually check for any foreign matter on the
platinum hot wire (heater) of the mass air flow
meter.
OK:
There is no foreign matter.
If the result is not as specified, replace the mass air
flow meter.
Measure the resistance according to the ...
Road test
1. PROBLEM SYMPTOM CONFIRMATION
HINT:
The dynamic laser cruise control system has two cruise
control modes: the constant speed control mode and
vehicle-to-vehicle distance control mode.
The vehicle-to-vehicle distance control mode is
always selected when starting up the dynamic laser ...
Installation
1. INSTALL REAR NO. 2 SEAT ASSEMBLY RH
Place the rear No. 2 seat assembly RH in the cabin.
NOTICE:
Be careful not to damage the body.
Install the seat with the bolt.
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
Install the locus cable RH with the bolt.
Torque: 29 N*m ( ...
