Toyota Sienna Service Manual: Removal
1. DISCHARGE FUEL SYSTEM PRESSURE
2. REMOVE V-BANK COVER SUB-ASSEMBLY
3. DRAIN ENGINE COOLANT
4. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
5. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY
6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
8. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
- Disconnect the 2 water by-pass hoses from the throttle body [A].
- Disconnect the vapor feed hose [B].
- Disconnect the throttle body connector and clamp [C].
- Disconnect the ventilation hose [D].
- Disconnect the union to check valve hose [E].
- Disconnect the connector [F].
- Using a 5 mm socket hexagon wrench, remove the 4 bolts [G].
- Remove the 2 nuts, 2 bolts and intake air surge tank [H].
- Remove the gasket from the intake air surge tank [I].
9. REMOVE FUEL MAIN TUBE SUB-ASSEMBLY
10. REMOVE INTAKE MANIFOLD
11. REMOVE KNOCK CONTROL SENSOR
- Disconnect the 2 knock sensor connectors.
- Remove the 2 bolts and then remove the 2 knock control sensors.
Knock sensor
COMPONENTS
...
Inspection
1. KNOCK CONTROL SENSOR
Using an ohmmeter, measure the resistance
between the terminals.
Resistance:
120 to 280 kΩ at 20C (68F)
If the resistance is not specified, replac ...
Other materials:
Power Slide Door RH does not Operate When Satellite Switch is
Pressed
DESCRIPTION
The power slide door operates only when the power slide door main
switch is ON (switch free: orange
paint on the top of the switch appears). The power slide door ECU RH
controls the power slide door
RH, which activates the slide door motor to open / close the slide do ...
Inspection
1. INSPECT SEAT HEATER SWITCH LH
Measure the resistance of the seat heater switch
when the switch is operated.
Resistance
If the result is not as specified, replace the switch.
HINT:
As the dial is being turned, the resistance changes
gradually.
Push the seat h ...
Throttle Actuator Control Motor Circuit
DESCRIPTION
The throttle actuator is operated by the ECM and opens and closes the
throttle valve using gears.
The opening angle of the throttle valve is detected by the Throttle Position
(TP) sensor, which is mounted
on the throttle body. The TP sensor provides feedback to the ECM. This ...
