Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Supplemental restraint system / Spiral cable / Removal

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

4. REMOVE STEERING WHEEL NO.3 COVER LOWER

5. REMOVE STEERING WHEEL NO.2 COVER LOWER

6. REMOVE STEERING PAD

7. REMOVE STEERING WHEEL ASSEMBLY

8. REMOVE STEERING COLUMN COVER

REMOVE STEERING COLUMN COVER

Remove the 2 screws and the steering column cover.

9. REMOVE SPIRAL CABLE

Disconnect the connectors from the spiral cable.

NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
Disengage the 3 claws and remove the spiral cable.

REMOVE SPIRAL CABLE

INSPECTION

1. INSPECT SPIRAL CABLE

If there are any defects as mentioned below, replace the spiral cable with a new one: Scratches, cracks, dents or chips on the connector or the spiral cable.

Installation

1. INSTALL SPIRAL CABLE Check that the front wheels are facing straight ahead. Set the turn signal switch to the neutral position. NOTICE: If it is not in the neutral pos ...

Other materials:

Removal
1. REMOVE REAR DOOR SCUFF PLATE 2. REMOVE REAR DOOR WEATHERSTRIP 3. REMOVE BACK DOOR WEATHERSTRIP 4. REMOVE BACK DOOR SCUFF PLATE 5. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY Remove the floor anchor cover. Remove the bolt and disconnect the No. 2 rear seat outer belt assem ...

Hood
COMPONENTS Adjustment HINT: Since a centering bolt is used as a hood hinge mounting bolt and hood lock mounting bolt, the hood and hood lock can not be adjusted with them on. Substitute a bolt with a washer for the centering bolt. 1. INSPECT HOOD SUB-ASSEMBLY Check that the clearance is ...

Rear washer motor
ON-VEHICLE INSPECTION 1. INSPECT REAR WASHER MOTOR Pour the water into the washer jar with the rear washer motor assembly installed to the washer jar assembly. Connect the battery (+) to the terminal 1 of the rear washer motor assembly, the battery (-) to the terminal ...