Toyota RAV4 manuals

Toyota Sienna Service Manual: Removal

HINT:

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE FRONT AIRBAG SENSOR LH

REMOVE FRONT AIRBAG SENSOR LH

  1.  Disconnect the connector from the front airbag sensor LH.
  2.  Remove the 2 bolts and the front airbag sensor LH.
On-vehicle inspection
1. INSPECT FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. 2. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT D ...

Installation
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. INSTALL FRONT AIRBAG SENSOR LH  Check that the ignition ...

Other materials:

Room Temperature Sensor Circuit
DESCRIPTION This sensor detects the cabin temperature that is used as the basis for temperature control and sends a signal to the A/C amplifier. WIRING DIAGRAM INSPECTION PROCEDURE 1 READ VALUE OF INTELLIGENT TESTER (a) Connect the intelligent tester to the DLC3. (b) Turn the ignition s ...

Precaution
1. Before operating the power rear no. 2 seat with stowing function, make sure that there is nothing in the path of the seat. CAUTION: If someone or something is caught between the seat and other parts, injury or damage may result.  If the system detects that the folding motor is locke ...

Magnetic clutch relay
ON-VEHICLE INSPECTION 1. INSPECT MAGNETIC CLUTCH RELAY (a) Remove the magnetic clutch relay. (b) Measure the resistance according to the value(s) in the table below. Standard resistance If the resistance is not as specified, replace the magnetic clutch relay. ...

В© 2011-2024 Copyright www.tsienna.net