Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Supplemental restraint system / Side airbag sensor / Removal

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE FRONT DOOR SCUFF PLATE LH

4. REMOVE REAR DOOR SCUFF PLATE LH

5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

6. REMOVE REAR DOOR WEATHERSTRIP LH

7. REMOVE LAP BELT OUTER ANCHOR COVER LH

8. REMOVE CENTER PILLAR GARNISH LOWER LH

9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

10. REMOVE SIDE AIRBAG SENSOR LH

REMOVE SIDE AIRBAG SENSOR LH

Disconnect the connector from the side airbag sensor LH.
Remove the 2 nuts and the side airbag sensor LH.

On-vehicle inspection

1. INSPECT SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION) Perform a diagnostic system check. 2. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEP ...

Installation

HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. INSTALL SIDE AIRBAG SENSOR LH Check that the ignition switch ...

Other materials:

Removal
1. Disconnect cable from negative battery terminal 2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) (See page EC-32) 3. REMOVE TAIL EXHAUST PIPE ASSEMBLY (a) Remove the 2 bolts. (b) Disconnect the 3 exhaust pipe supports and remove the tail exhaust pipe assembly. (c) Remove the gas ...

Front Speed Sensor RH Circuit
DESCRIPTION The speed sensor detects wheel speed and transmits the appropriate signals to the ECU. These signals are used for control of the ABS control system. The front and rear rotors have 48 serrations each. When the rotors rotate, the magnetic field generated by the permanent magne ...

Mirror Switch Circuit
DESCRIPTION A switch signal of the outer mirror switch is transmitted to the selected outer mirror control ECU by way of the body ECU. Then, the outer mirror control ECU activates the mirror motor to move the mirror UP, DOWN, RIGHT and LEFT in response to the inputs. HINT: Th ...