Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Supplemental restraint system / Rear airbag sensor / Removal

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE REAR DOOR SCUFF PLATE RH

4. REMOVE REAR DOOR WEATHERSTRIP RH

5. REMOVE BACK DOOR WEATHERSTRIP

6. REMOVE BACK DOOR SCUFF PLATE

7. REMOVE LAP BELT OUTER ANCHOR COVER

8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

9. REMOVE AIR DUCT ASSEMBLY

Remove the screw and the air duct assembly.

10. REMOVE REAR AIRBAG SENSOR LH

REMOVE REAR AIRBAG SENSOR LH

Disconnect the connector from the rear airbag sensor LH.
Remove the 2 bolts and the rear airbag sensor LH.

On-vehicle inspection

1. INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION) Perform a diagnostic system check. 2. INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEP ...

Installation

HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. INSTALL REAR AIRBAG SENSOR LH Check that the ignition ...

Other materials:

Repeat play
Select to change on/off. Using cellular phones Interference may be heard through the audio system’s speakers if a cellular phone is being used inside or close to the vehicle while the audio system is operating. Certification (caution) Laser product This product is a class 1 laser product. ...

DTC check / clear
HINT: If the system cannot enter the diagnostic mode, inspect all AVC-LAN communication signals and repair or replace problem parts. 1. STARTING DIAGNOSTIC MODE Turn the ignition switch to the ACC position. Turn off the audio system. While pressing the preset switche ...

How to proceed with troubleshooting
1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS 3 CHECK INITIAL CHECK FUNCTION 4 PROBLEM SYMPTOMS TABLE THE CORRESPONDING SYSTEM DOES NOT EXIST (Go to step 5) 5 BASED ON THE MALFUNCTION SYMPTOM, PERFORM THE TROUBLESHOOTING BELOW Operation check (C). Terminals of ECU 6 ...