Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Mirror / Outer rear view mirror / Removal

HINT: On the RH side, use the same procedures as on the LH side.

1. REMOVE FRONT DOOR SERVICE HOLE COVER LH

Remove the front lower frame bracket garnish LH.
Remove the front door inside handle bezel plug LH.
Remove the front armrest base panel upper LH.
Remove the power window regulator master switch.
Remove the front door trim board LH.
Remove the front door service hole cover LH.

2. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Disconnect the connector.
Remove the 3 nuts and mirror.

Inspection

1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (w/o Memory) Disconnect the mirror connector. Check operation of the outer mirror. Apply battery voltage and inspect operation ...

Other materials:

Installation
1. Install generator assembly (a) Install the bracket with the bolt. Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) (b) Install the wire harness clamp stay. Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) (c) Connect the wire harness clamp. (d) Install the generator assembly to the cylinder ...

Bulb locations
Front Vehicles without daytime running lights or with bulb type daytime running lights Headlight high beam and daytime running lights (if equipped) Headlight low beam (halogen bulb) Fog light (if equipped) Front turn signal/parking and front side marker lights Vehic ...

Problem symptoms table
When a "Normal" code is output during a DTC check but the problem still occurs, use the Problem Symptoms Table. The suspected areas (circuits or parts) for each problem symptoms are in the table. The suspected areas are listed in order of probability. A description of each of the char ...