Toyota Sienna Service Manual: Removal
1. REMOVE CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for center seat).
- Remove the bolt and center seat lap type belt assembly.
2. REMOVE CENTER REAR NO. 2 SEAT LAP BELT ASSEMBLY WITH INNER
HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Remove the bolt and center rear No. 2 seat lap belt assembly with inner.
3. REMOVE REAR NO. 2 SEAT BELT ASSEMBLY INNER
HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Remove the bolt and rear No. 2 seat belt assembly inner.
Rear center seat inner belt assembly
COMPONENTS
...
Installation
1. INSTALL CENTER REAR SEAT LAP TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for reassembly of the rear No. 1
seat assembly (for center seat).
Install the center ...
Other materials:
CD cannot be Inserted / Played or CD is Ejected Right After Insertion
INSPECTION PROCEDURE
1 CHECK IF A PROPER CD IS INSERTED
Make sure that the CD is an audio CD or a CD with an
MP3 or WMA file, and that it is not deformed, flawed,
stained, burred, or otherwise defective.
OK:
Normal CD
HINT:
Translucent or uniquely-shaped CDs cannot be
playe ...
TS and CG Terminal Circuit
DESCRIPTION
In the sensor check mode, a malfunction of the speed sensor that cannot be
detected when the vehicle is
stopped is detected while driving.
Transition to the sensor check mode can be performed by connecting terminals TS
and CG of the DLC3
and turning the ignition switch from off ...
Disassembly
HINT:
Overhaul the RH side by the same procedures as these of
the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER
ASSEMBLY LH
HINT:
Do not disconnect the flexible hose from the brake
caliper.
3. REMOVE REAR DISC
(a) Release the parking brake, and remove the rear
disc.
H ...
