Toyota Sienna Service Manual: Removal
1. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No .1 seat assembly (for center seat).
- Remove the rear seatback board.
- Remove the rear seat shoulder belt cover.
- Remove the 2 bolts, 2 nuts and No. 1 rear seat outer belt assembly.
2. REMOVE 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
- Remove the roof headlining.
HINT: Refer to the instructions for removal of the roof headlining.
- Remove the 2 bolts, 2 nuts and 3 point type No. 2 rear seat belt assembly.
Rear center seat outer belt assembly
COMPONENTS
...
Installation
1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
Check the degree of tilt when the belt begins to lock
the ELR.
Check that the belt does not lock within 15 of
tilt i ...
Other materials:
Transmission Range Sensor Circuit Malfunction (PRNDL Input)
DESCRIPTION
The park/neutral position switch detects the shift lever position and sends
signals to the ECM.
HINT:
After confirming DTC P0705, use the intelligent tester to confirm the PNP
switch signal in the ALL menu
(to reach the ALL menu: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ...
Hazard warning switch
INSPECTION
1. HAZARD WARNING SIGNAL SWITCH ASSEMBLY
Check that there is resistance between the
terminals at each switch position as shown in the
chart.
Resistance
Inspect illumination operation.
Connect the positive (+) lead from the battery
to the termina ...
Installation
1. INSTALL SEAT MEMORY SWITCH
2. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY
LH
3. INSTALL POWER WINDOW REGULATOR MASTER
SWITCH ASSEMBLY
4. INSTALL FRONT DOOR INSIDE HANDLE BEZEL
PLUG LH
5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
Engage the 4 claws to install the seat me ...
