Toyota Sienna Service Manual: Removal
CAUTION:
- Wear safety gloves, because the sharp surfaces of the seatback frame and seat adjuster may injure your hand.
- Work must be started more than 90 seconds after the
ignition switch is turned to the LOCK position and the
negative (-) terminal cable is disconnected from the
battery.
(The SRS is equipped with a back-up power source. If work is started within 90 seconds from disconnecting the negative (-) terminal cable from the battery, the SRS may deploy.)
1. REMOVE FRONT SEAT HEADREST ASSEMBLY
2. REMOVE FRONT SEAT ASSEMBLY RH
- Using a screwdriver, pry out the 2 seat track covers.
HINT: Tape the screwdriver tip before use.
- Disconnect the connectors under the seat assembly.
- Remove the 4 bolts and the sat assembly.
NOTICE: Be careful not to damage the body.
Front seat assembly (for Flat Type)
COMPONENTS
...
Disassembly
1. REMOVE OCCUPANT CLASSIFICATION ECU
2. REMOVE FRONT SEAT CUSHION SHIELD INNER RH
Remove the screw.
Using a screwdriver, disengage the claws and
remove the cushion shield inner.
...
Other materials:
Removal
1. REMOVE OUTSIDE MOULDING
Put protective tape around the outside moulding.
Using a heat light, heat the moulding between 40 to
60 C (104 to 140 F).
NOTICE:
Do not heat the moulding excessively.
Tie both piano wire ends to a wooden block or a
similar object.
Cut off the tape by ...
Terminals of ECU
1. MULTIPLEX NETWORK GATEWAY ECU
Disconnect the G4 ECU connector.
Measure the voltage between the specified
terminals on the wire harness side connector.
If the result is not as specified, there may be a
malfunction on the wire harness side.
Measure the resistance between ...
System description
1. OUTLINE OF THEFT DETERRENT SYSTEM
When the theft deterrent system detects that the
vehicle is being tampered with, the system sets off
the alarm, causing the horns to sound and the lights
to light up or blink in order to alert people around the
vehicle to the theft.
The ...
