Toyota Sienna Service Manual: Removal
CAUTION:
- Wear safety gloves, because the sharp surfaces of the seatback frame and seat adjuster may injure your hand.
- Work must be started more than 90 seconds after the
ignition switch is turned to the LOCK position and the
negative (-) terminal cable is disconnected from the
battery.
(The SRS is equipped with a back-up power source. If work is stated within 90 seconds from disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)
HINT: Use the same procedures for the RH side and LH side.
1. REMOVE FRONT SEAT HEADREST ASSEMBLY
2. REMOVE FRONT SEAT ASSEMBLY LH
- Using a screwdriver, pry out the 2 seat track covers.
HINT: Tape the screwdriver tip before use.
- Disconnect the connectors under the seat assembly.
- Remove the 4 bolts and the seat assembly.
NOTICE: Be careful not to damage the body.
Front seat assembly (for Manual Seat)
COMPONENTS
...
Disassembly
1. REMOVE FRONT SEAT SIDE TABLE LEG COVER (w/
Table)
Using a screwdriver, disengage the claws and
remove the seat side table leg cover.
HINT:
Tape the screwdriver tip before use.
2. ...
Other materials:
Calling the message sender
Calls can be made to an e-mail/SMS/MMS message sender’s phone
number.
Display the message inbox screen.
Select the desired message.
Select .
Check that the “Call” screen is displayed.
Calling from a number within a message
Calls can be made to a number identified in a message ...
Poor Sound Quality in All Modes (Low Volume)
INSPECTION PROCEDURE
1 CHECK AUDIO SETTINGS
Set "BASS", "MID", and "TREB" to the initial values and
check that sound is normal.
OK:
Malfunction disappears.
2 COMPARE WITH ANOTHER VEHICLE OF SAME MODEL
Compare with another vehicle of the same model.
...
Suspension
SERVICE DATA
A: Ground clearance of front wheel center
B: Ground clearance of lower suspension arm No. 2 set bolt
center
C: Ground clearance of rear axle carrier bush set bolt center
D: Ground clearance of rear wheel center
TORQUE SPECIFICATIONS
TIRE AND WHEEL
SERVICE DATA
T ...
