Toyota Sienna Service Manual: Removal
1. REMOVE REAR SEAT LEG SIDE GARNISH SUBASSEMBLY LH
- Disengage the clips and remove the seat leg side garnish.
2. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
- Remove the bolt and locus cable.
- Remove the 2 bolts and seat.
- Remove the 2 headrests.
Rear no. 2 Seat assembly (for Manual Seat Type LH
Side)
COMPONENTS
...
Disassembly
1. REMOVE RH SEAT REAR SEAT RECLINING COVER
Remove the 2 screws.
Remove the RH seat rear seat reclining cover by
pulling it out in the arrow mark direction shown in
the illus ...
Other materials:
Operation check
1. ILLUMINATED ENTRY SYSTEM OPERATION CHECK
The illuminated entry system is explained below:
Turn the ignition switch OFF, close all the doors,
and set them in the lock condition.
Unlock any door and open any other doors and
check that the room light comes on. Close ...
Actuator Supply Voltage Circuit / Open
DTC P0657 Actuator Supply Voltage Circuit / Open
DESCRIPTION
The ECM monitors the output voltage to the throttle actuator. This self-check
ensures that the ECM is
functioning properly. The output voltage is usually 0 V when the ignition switch
is turned off. If the output
voltage is higher t ...
Terminals of ECU
1. CHECK TRANSPONDER KEY AMPLIFIER
Disconnect the I14 amplifier connector and measure
the resistance between the terminal of the wire
harness side connector and body ground.
If the result is not as specified, there may be a
malfunction on the wire harness side.
Reconnec ...
