Toyota Sienna Service Manual: Removal
1. REMOVE REAR SEAT LEG SIDE GARNISH SUBASSEMBLY RH
- Disengage the clips and remove the seat leg side garnish sub-assembly RH.
2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH
- Remove the bolt and locus cable RH.
- Remove the 2 bolts and rear No. 2 seat assembly RH.
- Remove the rear seat headrest assembly RH.
Rear no. 2 Seat assembly (for Manual Seat Type RH Side)
COMPONENTS
...
Disassembly
1. REMOVE RH SEAT REAR SEAT RECLINING COVER
Remove the 2 screws.
Remove the RH seat rear seat reclining cover by
pulling it out in the arrow mark direction shown in
the illus ...
Other materials:
Rear Power Seat Switch Circuit
DESCRIPTION
When the power rear no. 2 seat switch is operated, a recline signal is sent
to the fold seat control ECU.
The ECU activates the reclining motor based on the signal from the power rear
no. 2 seat switch.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FOLD SEAT CONTROL ECU
...
Camshaft Position "A" Actuator Circuit
DTC P0010 Camshaft Position "A" Actuator Circuit (Bank
1)
DTC P0020 Camshaft Position "A" Actuator Circuit (Bank
2)
DESCRIPTION
The Variable Valve Timing (VVT) system includes the ECM, Oil Control Valve (OCV)
and VVT controller.
The ECM sends a target duty-cycle control ...
Laser Sensor Power Source Circuit
DESCRIPTION
This circuit provides power to the laser sensor. The laser sensor emits radio
waves towards an object in
front and measures the distance and direction of the object by receiving the
beam reflections. Based on
the reflections, the sensor calculates the difference in speed between t ...
