Toyota Sienna Service Manual: Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR NO. 2 SEAT LEG SIDE GARNISH SUB-ASSEMBLY
- Disengage the 9 clips and remove the rear No. 2 seat leg side garnish sub-assembly.
- Remove the 9 clips from the rear No. 2 seat leg side garnish sub-assembly.
3. REMOVE REAR SEAT LEG SIDE GARNISH SUBASSEMBLY
- Disengage the 4 clips and remove the rear seat leg side garnish sub-assembly.
- Remove the 4 clips from the rear seat leg side garnish sub-assembly.
4. REMOVE NO. 2 SEAT HINGE COVER
- Disengage the 8 claws and remove both No. 2 seat hinge covers.
5. REMOVE REAR NO. 2 SEAT ASSEMBLY
- Disconnect the connector.
- Remove the 8 bolts.
- Pull the lever under the No. 2 seat cushion subassembly and remove the rear No. 2 seat assembly.
Rear no. 2 Seat assembly (for Power Seat Type LH Side)
COMPONENTS
...
Disassembly
1. REMOVE REAR NO. 2 SEAT COVER BEZEL
Remove the 5 screws.
Disengage the 5 claws and remove the rear No. 2
seat cover bezel.
2. REMOVE REAR SEAT RECLINING COVER LH
& ...
Other materials:
Removal
1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
3. REMOVE FRONT DOOR ARMREST BASE PANEL
ASSEMBLY
4. REMOVE BACK FRAME PLATE
5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
6. REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY
7. REMOVE OUTER RE ...
Disposal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
When scrapping a vehicle equipped with the SRS or
disposing of the curtain shield airbag assembly, be sure to
deploy the airbag first in accordance with the proce ...
Starting the engine
Check that the parking brake is set.
Check that the shift lever is set in P.
Firmly depress the brake pedal.
The engine switch indicator will turn green. If the indicator does not turn
green, the engine cannot be started.
Press the engine switch.
The engine will crank until it sta ...
