HINT: On the RH side, use the same procedures as on the LH side.
1. REMOVE BACK DOOR STAY SUB-ASSEMBLY LH
Reassembly
1. INSTALL REAR DRIVE SHAFT OUTBOARD JOINT BOOT
HINT:
Before install the boot, wrap the spline of the outboard
joint shaft with vinyl tape to prevent the boot from
bearing damaged.
(a) Install new outboard joint boot, 2 outboard joint boot
clamps, 2 inboard joint boot clamps and inboard
j ...
Data list / active test
HINT:
By accessing the DATA LIST displayed on the intelligent
tester, you can perform such functions as reading the values
of switches and sensors without removing any parts. Reading
the DATA LIST as the first step in troubleshooting is one
method to shorten labor time.
1. DATA LIST FOR CENTER ...
Turbine Speed Sensor Circuit No Signal
DESCRIPTION
This sensor detects the rotation speed of the input turbine. By comparing the
input turbine speed signal
(NT) with the counter gear speed sensor signal (NC), the ECM detects the shift
timing of the gears and
appropriately controls the engine torque and hydraulic pressure accor ...