Toyota Sienna Service Manual: Removal
1. REMOVE REAR BUMPER COVER
- Put protective tape under the quarter panel.
- Partially the fender liner.
HINT: Do not remove the fender liner completely but partially so that the bumper cover can be removed.
- Remove the 2 screws and 8 clips.
- Using a screwdriver, disengage the claws and
remove the cover.
HINT: Tape the screwdriver tip before use.
Rear bumper
COMPONENTS
...
Disassembly
1. REMOVE NO. 1ULTRASONIC SENSOR RETAINER
(w/ Clearance Sonar System) (See page PM-19)
2. REMOVE NO. 1 ULTRASONIC SENSOR (w/
Clearance Sonar System) (See page PM-19)
3. REMOVE REAR BUMPER ENERGY A ...
Other materials:
Clock setting
Display the “General Settings” screen.
Operations up to this point can also be performed by select the clock
display
at the top of most screens.
Select the items to be set.
Manual clock setting
Set minutes to 00
The 24-hour time format can
be to on/off.
Select ...
System Voltage
MONITOR DESCRIPTION
The battery supplies electricity to the ECM even when the ignition switch is
off. This power allows the
ECM to store data such as DTC history, freeze frame data and fuel trim values.
If the battery voltage falls
below a minimum level, these memories are cleared and the ...
Precaution
1. INITIALIZATION
NOTICE:
Perform RESET MEMORY (AT initialization) when
replacing the automatic transaxle assembly, engine
assembly or ECM (See page AX-16).
Perform REGISTRATION (VIN registration) when
replacing the ECM (See page ES-15).
HINT:
Initializatio ...
