Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Exterior / Rear spoiler / Removal

1. REMOVE BACK DOOR CENTER GARNISH

REMOVE BACK DOOR CENTER GARNISH

Using a clip remover, disengage the 5 clips to remove the back door center garnish.

2. REMOVE REAR SPOILER

Disconnect the center stop light connector.

REMOVE REAR SPOILER

Remove the 3 nuts.
Using a clip remover, disengage the 2 clips to remove the rear spoiler.

3. REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY

Installation

1. INSTALL HIGH MOUNTED STOP LIGHT ASSEMBLY 2. INSTALL REAR SPOILER Install the rear spoiler with the 3 nuts and 2 clips. Connect the center stop light connector. 3. INSTALL BACK DOOR CE ...

Other materials:

Reassembly
1. INSTALL POWER SLIDE DOOR TOUCH SENSOR LH Install the touch sensor with the 4 screws. Connect the connector. Fix the wire harness inside the door panel with the clip. 2. INSTALL REAR DOOR WIRE SUB-ASSEMBLY LH Install the wire. NOTICE: When installing the wire, push the ...

The keys
The following keys are provided with the vehicle. Vehicles without a smart key system Master keys (black) Valet key (gray) Key number plate Vehicles with a smart key system Electronic keys Operating the smart key system Operating the wireless remote contr ...

Cooling fan relay
On-vehicle inspection 1. Cooling fan relay (a) Remove the relay from engine room relay block No. 1. (b) Measure the resistance of the relay. Standard resistance If the result is not as specified, replace the cooling fan relay. (c) Install the relay to engine room relay block No. ...